Solar energy is welcomed by many people, and many families or individual travelers choose to buy solar panels. How to install solar panels? I believe this article is useful information for you who want to install solar panels. When installing solar panels, you must pay attention to the following points:
A solar panel is a device that directly or indirectly converts solar radiation into electrical energy through the photoelectric effect or photochemical effect by absorbing sunlight. So it is very important to install the solar panel in the place with the most direct sunlight.
Solar panels perform at optimal capacity when exposed to direct, intense sunlight, absorbing more light energy into electricity. So, it is important to remember that when you install your solar power system, not in rainy weather, but in full sun, to get the most out of your PV units and to test your solar panels to see if they work well.
clear all obstacles
Before installation, pay attention to the blocking of sunlight, and also remove all unnecessary obstacles, such as large trees and tree branches, which may block sunlight to your solar installation. You should also trace the path of the sun in the sky, see where the sun is directly shining at different times, and finally make sure that nothing is casting a shadow on your PV panels. If obstacles are not blocked effectively, the operating efficiency of your solar panels will suffer due to these obstacles.
make good use of your time
When installing your solar panels, you have to learn to take advantage of the time, from 12:00 noon to 1:00 pm when the direct sunlight is the strongest, at this time the solar panels can work with maximum power and can also give you the necessary storage. able condition.
Pay attention to the above points when installing solar panels. Next, I will share with you ten tips for installing solar panels.
1.The system is to be installed by qualified personnel only. The system involves electrical energy and can be dangerous to members who are not familiar with qualified safety procedures.
2.Do not immerse PV modules in water or continuously expose them to sprinklers or fountains.
3.When choosing a site, avoid choosing trees, buildings or places with shade that will block solar modules especially in winter. PV module installations should be secured to a permanent frame and should be inclined towards optimum winter performance.
4.The photovoltaic modules connected in series should be installed in the same direction and angle. Installation in different directions and angles will cause energy loss due to differences in sunlight radiation.
5.It is strictly forbidden to short-circuit the positive and negative poles.
6.Whether the fastening part of the installation structure is loose, it must be tightened.
7.Always use a soft cloth to remove the dust and dirt on the surface of the photovoltaic module to prevent the loss of output power due to the blocking of the surface of the module. Usually, it is necessary to check whether the surface of the component is blocked by objects.
8.Be careful not to touch the bare parts of the wires or connectors, and bring insulating devices (such as tools, gloves, etc.) if necessary.
9.When installing and maintaining the product, be sure to cover the surface of the module with cloth or other opaque materials, because it is dangerous for the module to generate high voltage under sunlight.
10.The system cannot be placed in salt-corroded and vulcanized, wet areas.
In general, solar panels are green products that are energy-saving and environmentally friendly, and more and more people are starting to buy and use them, but also keep in mind the above points and tips when installing to convert the energy and power of your solar panels Play to the maximum.